The wholesaler for smart home professionals
Shipping within 24h
B2B portal
Direct delivery from stock
Technical support

Aeotec Water Sensor 8

The Aeotec Water Sensor 8 detects leaks via a probe and reports temperature, humidity and dew point. Z-Wave Plus Long Range, S2, battery or USB-C power.
Product number: ZWA056-C
Manufacturer: Aeotec
EAN: 1220000017436
Product information "Aeotec Water Sensor 8"

The Aeotec Water Sensor 8 is a compact Z-Wave sensor for leak detection and climate monitoring in professional installations. The sensor body is mounted on a dry, flat surface; the supplied water probe (approx. 177 cm) is placed where water may collect, for example under a sink, beside a boiler or in a plant room.

In addition to water contact detection, the device measures temperature, relative humidity and dew point. A mould-risk notification can be issued when humidity remains high. State changes, tamper events and battery status are sent to the controller as Z-Wave Notification reports. Association groups allow other Z-Wave devices to be controlled directly on a leak, temperature threshold, humidity threshold or mould-risk event.

Water Sensor 8 is built on the Z-Wave 800 chipset (EFR32ZG23) and supports Z-Wave Plus v2, Z-Wave Long Range, S2 security, SmartStart and over-the-air firmware updates. The EU version (ZWA056-C) operates at 868.4–869.8 MHz. Power is supplied by a CR14250 battery (up to around two years at factory defaults) or optionally via USB-C (5 V). When continuously powered over USB, the device can act as a repeater in the mesh network.

The unit measures 69.9 × 17.8 × 19.6 mm and is intended for indoor use. The sensor body must not be installed in damp or wet locations; only the probe should come into contact with water. Mounting is possible with the supplied double-sided tape or with screws and wall anchors.

Features

  • Leak detection via an external water probe of approx. 177 cm
  • Temperature, humidity and dew-point measurement
  • Notifications for mould risk, tamper and low battery
  • Z-Wave Plus v2, Long Range, S2 and SmartStart
  • Powered by a CR14250 battery or USB-C (5 V)
  • OTA firmware updates; repeater function when USB-powered

Installation, commissioning and configuration must be carried out by a qualified installer, in accordance with the manual and applicable regulations.

Properties
Communicatie & Protocol: Z-Wave
Operating temperature: 0-40°C
Power source: Battery or constant power via USB-C port
Protocol: Z-Wave Long Range
Downloads "Aeotec Water Sensor 8"